You are here

Add Selection

Products » ImBatch

Batch Add Selection Image task
Add Selection

Description Creates a new selection area by adding, subtracting, or replacing the selection area of the specified form.

Parameters:
Selection Type Specifies the form of the new selection. Possible values:
Rectangle - a rectangular selection.
Ellipse - a selection of the elleptical form.
Rounded Rectangle - a rectangular selection with rounded corners.
Left Position Specifies the position of the left border of the selection.
Right Position Specifies the position of the right border of the selection.
Top Position Specifies the position of the top border of the selection.
Bottom Position Specifies the position of the bottom border of the selection.
Round Width Specifies the width of a rounded rectangle. This parameter is visible only if the Selection Type is set to Rounded Rectangle.
Round Height Specifies the height of a rounded rectangle. This parameter is visible only if the Selection Type is set to Rounded Rectangle.
Selection Operation Specifies the type of operation, that is performed when adding a new selection. It has the following values:
Replace - existing selection is replaced by the new one.
Add - adding the new selection to the existing one.
Subtract - subtracts the new selection from the existing one.
Intensity Specifies the intensity of the new selection. The range is from 0 to 255, where 0 - no selection, 255 - the maximum intensity of the selection.
Copyright © 2013-2017 High Motion Software. All rights reserved. | Legal Notices